We all know that the vibration plate is accurately transmitted by imported Mitsubishi servo motors, and the motor drive system drives the drum. Therefore, compared with other vibrating plates, it has the advantages of more accuracy and stability, which is an important reason why many customers choose vibrating plates as transmission equipment. The NC vibrating disc shunt test and use are easier than other types of feeding equipment, but we still have various problems during the installation and use process, not the equipment itself. It is also common for us to convey materials inaccurately during feeding. When these problems occur, how do we find out the reasons and make adjustments? CNC vibration plate 1. There are problems with the quality of the transmission material itself, which is prone to slip and deviation. The CNC vibrating plate has smooth material. After deflection, check the quality of the material itself to check whether there is any bending, unevenness, uneven material thickness, and heavy side edges of the material. If this happens, the qualified material must be replaced. . 2. The uneven pressure of the compression spring in front of the NC vibrating table causes sliding and deflection. When using the compression spring of the NC vibrating plate, the left and right pressure should remain the same. At the same time, it should be ensured that the compression spring really has a pressing material, so it is standard that the material cannot be pulled by hand. 3. Is there a problem with the stamping die? You can try to test the machine manually to confirm whether there is a problem with the mold. No matter whether the material is oily or not, it is easy to cause the side slip of the feeding material, and the servo addition and subtraction time is too short. 4. Check whether the installation position of the mold is aligned with the NC vibration plate. If it is not a straight line, the feed of the vibrating plate is insufficient, and there will be a feed error in a fixed direction. 5. Check whether the punching speed of the adapter punch is too fast. Generally, the maximum feed rate of the pneumatic NC vibrating plate is about 60-120 times per minute, while the maximum feed rate of the mechanical NC is about 150-200 times per minute. This depends on the response time and relaxation time of the servo control system. If the actual punching speed is too fast, the feed of the vibrating plate will not keep up, resulting in feed errors. Servo vibration plate 6. When the vibrating plate is feeding, the vibration behind the material is too large, which will also cause inaccurate feeding. 7. Whether the pressure is unstable, we can check carefully. Check whether the NC vibration plate is leaking (depending on whether it is pneumatic or mechanical). 8. Check whether the feed time of the vibration plate is set too late. When the feed step of the vibrating plate is longer and the feed time is set late, the feed time will not complete the full feed and a direction error will occur. According to the above steps, we can basically confirm the reason for the inaccuracy of the vibration plate. I hope this article can help you solve the problem. The other must be installed and used according to the instructions. Only when the vibration plate is installed correctly, the machine and equipment can play the best role.
