What problems should be paid attention to during the operation of the vibration plate of the packaging machine:
1. Possible reasons why the vibration plate of the packaging machine does not work
1. The power supply voltage is insufficient;
2. The connection between the vibration plate of the packaging machine and the controller is broken;
3. The controller fuse is blown;
4. The coil is blown;
5. The gap between the coil and the frame is too small or too large;
6. There are parts stuck between the coil and the frame;
7. The vibration plate of the packaging machine is against the hard object, and the top plate or the bottom plate touches other equipment.
2. The vibrating plate of the packaging machine is weak or too slow, and the material is fed sporadically or irregularly. Possible reasons:
1. The spring is broken;
2. The bottom plate is too thin;
3. The installation table is defective and lacks hardness. If suspended on the equipment table, the vibration will be too weak. The thickness of the table should be at least 1-1/2" so as not to absorb vibration. Cylindrical feet must be equipped with triangular support plates;
4. The table top is not level;
5. There are sundries in the plate;
6. The coil air gap should be as small as possible;
7. Too fast machine rhythm causes parts to slip off the vibrating plate;
8. Grid fluctuations;
9. The controller needs to be re-adjusted to adapt to grid fluctuations;
10. Parts problems: out of tolerance, bending, oily, etc.;
11. The fastening screws of the tray and the base are not tight or the position is wrong;
12. Too many parts;
13. Improper adjustment of the chassis;
14. If the material changes, the disk surface should be re-dressed and the chassis should be readjusted;
15. There may be some problems in the use of air blowing. There may be: unstable air pressure, air pollution, water or oil, these pollutants will stay on the surface of the vibrating plate, causing the feeding speed to slow down or even stop. The air source must be clean, dry, and equipped with independent pressure regulators and filters. Do not use rigid pipes that will reduce the feeding performance. Instead, use flexible hoses.
