Screw hardware packaging machine is now widely used in various fields. If it is used for a long time, some problems will inevitably occur during the production process. Many users who use spiral hardware packaging machines may have encountered such problems. The screw hardware packaging machine will continue to cut after opening the packaging film. So what is the film about the film of the spiral hardware packaging machine? How to deal with it?
Reasons why screw hardware packaging machine film is cut constant:
1. The temperature of the cutting knife is not enough: if the temperature of the cutting knife is not enough, it will cause the packaging film to be cut, so we can try to increase the temperature a few degrees before trying it (remember that the temperature is increased for two or three minutes, wait for two or three minutes, wait After the temperature is stable, the test is tested). If the packaging membrane has been cut off, but folds appear after the packaging membrane is cut, indicating that the temperature is too high or the packaging machine is not enough (if the packaging machine is too slow, the temperature is too high, the packaging film will be burned). Since it is not a temperature problem, it depends on its achievements.
Hardware packaging machine
2. The screws on both sides of the screw hardware packaging machine loose: After the machine is used for a long time, due to the vibration of the machine, the two screws on the top of the blade may loosen. We need to adjust the screws on the blade twice or three times clockwise (note that it is not the big screw in the middle, but the small screws on both sides. Some packaging machines are four screws. Different models are different). After adjustment, we can turn on the power and leave the movie. Generally speaking, we can solve the problem of continuous cutting of the screw hardware packaging machine. If it doesn't work, we need to adjust around and then test slowly.
3. The cutting knife is not sharp enough: After the above reasons are excluded, the problem of cutting the knife can be concluded. This situation is more common, especially the long -term use of screw hardware packaging machines, most of them are cutting knives. The solution is that we can pad the blade with copper, so that the pressure of cutting knife will increase, and the film of the packaging machine can be cut off. Step: Remove the cutting knife (pay attention to the temperature of the other, then do this operation, otherwise it will be easy to scald). You can also use the aluminum skin on a copper or cut tank to cut into the appropriate width (as long as you can put it on the knife seat, you can meet the new standards. It should be noted that this operation is not suitable for novices. After the knife is removed, it is difficult to meet the standard of cutting the knife. This is only time -consuming and laborious. It is correct to contact the after -sales master of the screw hardware packaging machine as soon as possible to solve it.
