In the process of using the vertical furniture hardware packaging machine, because it is not adjusted well before use, or the operation is wrong, it will cause the vertical furniture hardware packaging machine to pull the film deviation, so what should I do if the vertical furniture hardware packaging machine pulls the film deviation?
1) After the packaging film is installed, start the test, and after the packaging film is made into a bag, there is a situation that the left side of the bag is shorter than the right side of the bag on the back of the bag. Next, adjust the former of the packaging machine according to the deviation of the packaging film.
2) The normal situation is that the left and right sides are aligned and uniform. After the left side is shorter than the right side, after adjusting the relevant screws and loosening the relevant screws:
3) After loosening the screws, if the right side of the back sealing edge is more than the left side, tap the H-type stainless steel plate to the left with a wrench to move the H-type stainless steel plate to the left, and move a little bit. Tighten the two screws No. 2. If the left side of the back seal is more than the right side, then the H-type stainless steel plate is knocked to the right (move to the right).
