Several problems with poor packaging machine packaging machine:
The problem that is easy to occur in the packaging machine is that the packaging amount is not good, and there are many factors that affect this problem.
1. The problem of packaging rolls, the packaging volume is not qualified, not produced by regular manufacturers. The probability of poor packaging is 97.35 %.
2. The packaging roll is not installed, there are two cases here.
The first is that the packaging roll is not packed in normal ways, such as reversing (causing hot bags, rolls on the axis). For example, there is no entangled shaft volume (the two layouts will be aligned, resulting in burns or burns), and the fixed packaging roll spring is too tight (small packaging. Cut from the middle or wroke wrinkles)
Maintenance measures: The packaging roll is correctly installed. The correct installation method: The second is the packaging volume, but the corner has wrinkles, which makes the packaging roll easy to burn, resulting in poor packaging measures: just pave the folds on the edge of the packaging roll.
Screw automatic packaging machine
3. Motor problem, the packaging machine may not rotate up (down) motors upper (down) motors
The motor does not rotate (the packaging will be cut into small pieces, and the phenomenon of pulling the bag will appear). If the motor is not rotated (there will be an unclean situation, note that if the knife is not turned), the motor will not rotate). The type of 150 packaging machine will only occur in the future situation
Maintenance measures: Repair motor
4. Two uniform packaging rolls (the packaging will wrinkle)
Maintenance measures: First, when the axis of the packaging machine is hot, use dry steel balls to clean the hot plastic in time, and the other is to adjust the packaging machine to take the roll -up card spring and align the packaging roll.
5. The packaging cannot be rolled and sealed (in general, the long side of the packaging is separated, and the short side is separated from the side and outside of the side), as shown in the figure: (there are four large screws on the side of the machine, the above two are the two are the two on the side of the machine, and the above two are the two are on the side of the machine. The edge of the edge is the inner tube, and the outside of the external tube is on the top; the following two are sealing tops)
Seal (the heating pipe is damaged, the top silk loosening) maintenance measures: replace the heating pipe, the two adjustment of the top of the port (generally as long as there are places can be sealed, this situation is normal heating pipe), you can twist a circle until the adjustment is adjusted.
Maintenance measures: Find whether it is internal or external pressure, and then screw into the corresponding screw (if it is twisted too tightly, the bag will deviate from it, it is recommended to be appropriate). If the heating pipe is damaged, the edge may not be sealed
6. Packaging rolling bias or wrinkle
Maintenance measures: Find the edge or seal, rely on the inside or outside, and then release the top wire (mainly proper debugging, too many sealing), remove the spring in the top wire, and reinstall it (the machine will lose elasticity, which will help help, which will help help, which will help help, which will help help, which will help help, which will help help. Yu recovered)
7. Temperature problem maintenance measures: Adjust the packaging temperature (the overall wrinkles of the packaging volume can reduce the temperature; if the packaging volume cannot be sealed, the temperature can be improved. It is recommended to adjust five degrees and five degrees. Actual temperature> 101, the temperature exceeds 130, the sealing will stop heating))
