1. Mechanical repair and maintenance
1. Lubricate the transmission parts every month, check whether the fasteners are loose, and clean the gears, racks, sprockets, chains, and screws of the machine. Clean the outer surface, cover, workbench and inner corners of the machine.
2. After the new machine has been running for three months, tighten the drive chain and belt. In the future, it should be checked regularly and tightened if there is any looseness.
Two, electrical maintenance
1. Frequently check the voltage at home and check whether the wire ends at the terminals in the electrical cabinet box are loose and whether there is fire.
2. To maintain the horizontal seal return ring, the power should be cut off regularly, and the carbon powder on the surface should be cleaned with soft gauze dipped in alcohol, and the pressure of the compression spring should be checked frequently. If the carbon brush is severely worn, it should be replaced in time.
3. The gear matched with the proximity switch should be cleaned regularly to wipe off the putty and metal debris between the teeth and teeth. Note that when the anti-cutting fails, you should first check whether the proximity switch is in the correct position and whether it is loose or damaged. It is forbidden to add oil to the place where the steel ball is placed on the anti-cutting sleeve shaft.
4. Non-professionals shall not open and fiddle with electrical parts to avoid damage or accidents.
5. If any abnormality is found during the operation of the machine, it should be stopped immediately, and it can be used only after being checked and repaired by professional technicians. You can also directly ask our after-sales service personnel.
6. After the equipment is used, the power must be turned off.
7. The technical parameters and procedures of the inverter and other control components have been set before leaving the factory. Don't try to change it without authorization, otherwise it will cause the machine to operate chaotically or crash.
8. Do not place wrenches, tools or other objects on the surface cover of the machine. Falling objects caused by the vibration of the machine will cause the machine to malfunction. The broken tableware should be cleaned up in time to avoid jamming of the transition chain.
Three, safety regulations
1. The equipment shell must be grounded reliably.
2. It is not allowed to probe inward or reach out to the longitudinal seal, horizontal seal, film drive roller and transmission system.
3. Do not operate with gloves.
4. Before driving, make sure that no one is repaired and dangerously approaching.
5. Do not touch all energized places.
6. People with long hair must wear safety helmets, and their hair must not be exposed to the work cap to prevent injuries caused by entanglement by the machine.
