Many customers have questions about the operation of fully automated spiral counting packaging machine:
Starting the Automatic Screw Counting Packaging Machine:
1.Turn on the machine and wait a few minutes until the horizontal and vertical seal and encoder reach the set temperature.
the Automatic Screw Counting Packaging Machine Parameter Settings:
1.Set production output, mold detection time (adjust close to switch test die), and set package continuously. Click the Settings column next to the desired parameter, go to Settings, and then adjust to production requirements. Click OK to save and exit.
2.Click the parameter settings button to access the primary unit parameter settings. According to the specific conditions of packaging and packaging requirements, determine the speed, length, time, bag sealing time time, film free time, etc..
Start the Automatic Screw Counting Packaging Machine:
1.Check that the electrical equipment and conveyor belt around the machine are connected correctly.
2.Make sure the parameters and temperature are set correctly.
3.Tap the "Auto" button to start Auto Mode, then tap "Start" to begin Auto Packing.
IV. INTRODUCTION Introduction: Manual adjustment of automatic screw counting packer:
If you need to make a manual adjustment (such as changing film), click the "Auto" button to switch to manual mode, and the manual button will be active.
Automatic spiral counting packaging machine maintenance: the main points of maintenance include cleaning, tightening, adjustment, lubrication, corrosion prevention, etc. In normal course of production, machine operators should strictly follow the maintenance manual and procedures to carry out regular maintenance, reduce wear and tear, eliminate potential problems, and extend the lifespan of the machine.
Maintenance of fully automated helix counting packaging machine includes routine maintenance, scheduled maintenance (divided into primary, secondary and tertiary maintenance) and special maintenance (including seasonal maintenance and shutdown maintenance).
Daily maintenance of automatic spiral counting packing machine: the focus of daily maintenance is cleaning, lubrication, inspection and tightening. This should be performed regularly during and after surgery. Major repairs are carried out on the basis of routine maintenance, with emphasis on lubrication, tightening, inspection of components and cleaning.
Secondary maintenance focuses on inspections and adjustments. Specifically, it involves inspecting the engine, clutch, transmission, drive components, steering and braking systems.
The three levels 3 maintenance focus on testing, adjusting, troubleshooting and balancing wear and tear of the components. It involves diagnosing and inspecting components that affect equipment performance or show signs of malfunction, and then making necessary changes, adjustments and repairs.
Seasonal maintenance of spiral automatic counting packaging machines refers to inspection and repair of the lubrication system, hydraulic system, cooling system, starting system, etc. The downtime maintenance of spiral automatic counting packer refers to the cleaning, maintenance, replacement and embalming of parts when the packing machine is temporarily unusable due to seasonal reasons (such as winter downtime).
