In daily life, automatic granule packaging machinery and equipment need to be maintained frequently. The maintenance method of automatic granule packaging machine is special, and parts need to be checked and adjusted. The maintenance process of automatic granule packaging machine is as follows:
1. When the drum moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make noise, turn the pulley by hand, and the tightness is appropriate. Too tight or too loose can cause damage to the machine. .
2. If the automatic granule packaging machine is out of use for a long time, the whole body of the machine must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth.
3. The automatic particle packaging machine regularly inspects the parts, once a month, to check whether the worm gear, worm, bolts on the lubricating block, bearings and other moving parts are flexible and worn. If defects are found, they should be repaired in time, and should not be used reluctantly.
4. After the automatic granule packaging machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it properly to prepare for the next use.
5. The automatic granule packaging machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
