When the automatic packaging machine is working, it mainly packs various products and separates the specific weight. In the process of using these equipment, sometimes there are problems of inaccurate increments. Let some people not know what is going on. If we can operate it correctly, many problems will be effectively solved. How to adjust the parameters of the automatic packaging machine:
1. The seams of the vertical sealing film of the automatic packaging machine are abnormally overlapped.
Removal method: adjust the left and right position of the material bucket.
2. Insufficient supply of automatic packaging machine is sometimes large and sometimes small.
Removal method: Loosen the screws first, and check whether there are foreign objects in the feed pipe and the discharge pipe, or the control seal in the feed pipe is not tight, adjust the sliding nut of the regulator to see if it still works.
3. After the automatic packaging machine is packed, the bag time is not stable and the length is short.
Removal method: the clamping clamp screw is loose, the clamping clamp bag is worn or oily, use household detergent to clean it, check that the film barrel cannot swing back and forth, and check whether the plastic bag is overweight.
4. There is no temperature or unstable temperature in the horizontal and vertical sealing of the automatic packaging machine.
Removal method: check whether the meter is working normally, whether the thermocouple is damaged or loosened off, whether the electric heating tube is damaged, whether the power supply lacks phase, or whether the wire end is loose.
5. The heat sealing of the automatic packaging machine is not ideal, and the bag breakage rate is high.
Removal method: replace the sticky cloth or adjust the position of the sticky cloth, check that the rubber pad is flat, if it is damaged, it should be adjusted and replaced. If the filling volume is too large, a small amount of air should be left and adjusted to a suitable temperature.
6. The automatic packaging machine transversely seals and cuts the bag abnormally or the bag's compressive strength is not enough.
Elimination method: remove the foreign matter on the horizontal sealing heating block, check whether the board on the heating block is loose, replace the rubber pad on the push plate, the thickness of the material film should be about 0.08mm, adjust the horizontal sealing pressure, and check the blade of the horizontal sealing heating block Whether there are scars.
The above content is an introduction to how to adjust the parameters of the automatic packaging machine. In the process of using the automatic packaging machine, we will encounter many failures. There is no way to avoid this because its daily working frequency is Very high, many parts will wear out during high-frequency work, and failures will naturally follow. However, you can rest assured that many faults can be solved relatively easily as long as you find a way to adjust them. KALLYMACHINE welcome inquiries
