Daily maintenance and maintenance of packaging machinery
The key to maintenance of packaging machinery: cleaning, debugging, tightening, lubrication, and rust prevention. In the normal production process, each machine maintenance staff should do it, according to the maintenance manual and maintenance procedures of the packaging equipment of the machine, strictly perform the maintenance work within the specified period, reduce the wear rate of the parts, eliminate the hidden dangers of failure, and extend The service life of the machine.
Maintenance is divided into: daily maintenance, regular maintenance (divided into: primary maintenance, intermediate maintenance, advanced maintenance), special maintenance (divided: seasonal maintenance, stop maintenance).
Daily maintenance
Focusing on cleaning, lubrication, inspection and tightening, routine maintenance should be carried out as required during and after work.
Elementary: Maintenance work is carried out on the basis of routine maintenance. The key tasks are lubrication, tightening, and inspection of all relevant parts and their cleaning.
Intermediate: Maintenance work focuses on inspection and adjustment. Specifically check the engine, clutch, transmission, transmission components, steering and braking components. Check the parts regularly, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other movable parts are flexible and worn. If any defects are found, they should be repaired in time and should not be used reluctantly.
Advanced: The focus of maintenance is to detect, adjust, eliminate hidden troubles and balance the degree of wear of each component. It is necessary to perform diagnostic testing and state inspection on the parts that affect the performance of the equipment and the parts with fault signs, and then complete the necessary replacement, adjustment and troubleshooting.
Seasonal maintenance
It means that the packaging equipment should focus on the inspection and repair of the fuel system, hydraulic system, cooling system and start-up system before the summer and winter.
Disable maintenance
It means that cleaning, face-lifting, supporting and anti-corrosion work should be done when packaging equipment needs to be out of service for a period of time due to seasonal factors (such as winter holidays). If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned, and the smooth surface of the machine parts shall be coated with anti-rust oil and covered with a cloth hood.
