Common faults and treatment methods of automatic counting packaging machine
Automatic counting packaging machine is mainly composed of metering device, transmission system, horizontal sealing device, vertical sealing device, cutting device, forming device, photoelectric monitoring system and other parts. This design mainly completes the design of the main components such as the overall machine, the bag forming device, the horizontal sealing device, the vertical sealing device, and the transmission system. The basic parameters of the main structure are designed and calculated, and the basic plan is determined.
Common failures and treatment methods of automatic counting packaging machines
When the typing is not clear, there is no typing, and the production date:
1. Check whether the fonts are arranged neatly and have uneven heights.
2. Check whether there is any tightening or falling off of individual characters.
3. Check whether the ribbon is used repeatedly without ink.
4. Check that the character and the ribbon are multiple shifted, and the top and bottom do not match, and the top of the character is outside the ribbon.
5. Check whether the ribbon is rolled into a strip (remove all the oil that is stuck on the round shaft due to the ink falling off the ribbon
6. The air pressure is not or insufficient, and it cannot reach the position.
7. The ribbon is used up, and the machine will automatically and continuously (see the position of the stopper at the proximity switch).
8. Check the distance of each movement of the ribbon. The distance is too close, the typing is not clear or there is no typing, and the distance is too far.
Fee ribbon.
9. The tension of the unwinding tension adjusting nut is moderate, the ribbon cannot be pulled if it is too tight, and the alarm is often triggered if it is too loose, which affects the speed.
Degree.
10. The adjustment of typing time (in the packaging touch screen) is not clear, so you can add less.
When the sealing is not up to standard or not sealing:
check temperature
(1) It can be gradually heated when it is not sealed.
(2) Check whether the heating plate is in good condition.
(3) Check whether the position of the front and rear tool holders is moderate.
(4) Check if there is any foreign matter in the front and rear tool holders, and clean it up.
(5) Check whether the air pressure is normal.
(6) Check whether the packaging film is folded.
(7) Check whether the movement of the knife holder is smooth.
